Engineering Manual - Transfer Position

Transfer Position

Floating Gap and Dead Plate

EASECON modular conveyor belt is assembled by linking modules to complete the belt, and it is driven by sprockets. The teeth of sprocket will be processed into the geometric ratio angle; when the belt surface passes through the sprocket, there will be a drop between the jointing top and the belt surface, that is the floating gap. Therefore, please pay attention to the floating gap when installing the dead plate, no matter what the loading products exit or enter the belt through the dead plate. Especially for the loading of miniature products.

When the products are passing through the dead plate and going to get into the belt surface, the dead plate should be 0.8mm higher than the belt surface.
When the products are passing through the dead plate and going to get off the belt surface, the dead plate should be 0.8mm lower than the belt surface.

Floating Gap Dimensional Reference Table (G)

unit : mm
Series	Thickness of Belt	Sprocket Diameter (PD)	Number of Teeth	Floating Gap ( G )
100	16	133	8	5.6
		164	10	4.5
		196	12	4.0
		260	16	3.0
200	10	64	8	2.6
		98	12	1.7
		163	20	1
300	15	120	8	4.3
300	15	185	12	3.3
400	7	26	8	1
		38.5	12	0.3
		76.5	24	0
500	13	93	12	1.3
500	13	190	24	0.5

怡旭鋼工業股份有限公司